
词语导航
基本信息
词语:三端测量
繁体:三端測量
拼音:sān duān cè liáng
英语翻译
【计】 three-terminal measurement
分词翻译
三端的英语翻译:
【计】 three-terminal测量的英语翻译:
guage; measure; meterage; scale; survey【化】 measurement
【医】 measurement; mensuration; survey
【经】 calibration; take the gauge of
翻译例句
1. 分析表明,线路末端三相故障时,线路首端的测量阻抗不与故障距离成正比。
The analysis shows that the measured impedance at the head of the line is not proportional to the fault distance when a three-phase fault occurs at the end of the line.
2. 相应地,它的测量电路采用具有三个输入端的变压器电桥,从而免除了电极边缘和外界干扰的影响。
A transformer-ratio arm bridge with three terminals is adopted as its measuring circuit to eliminate the influence of electrode edges and exterior interference.
3. 浮法玻璃生产线玻璃带厚度在线检测技术采用了激光三角法位移测量原理,在退火窑热端进行玻璃带测厚的方案。
Adopt laser trigonometry displacement measure theory in the detection of glass thickness on line and the method in the hot side of annealing kiln.
4. 对用于有机导体电导测量的电压端短路法(VSC)提出了一个三层的串-并联物理模型。
A three layer series-parallel model of the Voltage Shorted Compaction (VSC) method for conductivity measurement of organic conductor was proposed.
5. 针对三缸往复泵测量信号非平稳时变特点,研究了用小波消噪方法提取反映往复泵动力端状态的振动波形特征。
With a view to time_varying characteristic of the vibration signal measured on triplex reciprocating pump, an approach on the waveform feature extraction which reflects th...
6. 光敏三极管与发光二极管沿径向安装于端盖上形成测量头。
The phototransistor and the light emitting diode are arranged on the end cover along a radical direction to form a measurement head.
7. 在以往的研究中,由于受到三轴试样变形测量手段的限制,无法定量研究三轴试样的端部约束对试样受力变形及其测量结果的影响。WwW.WeNTIyi.COm
Because of limitations of deformation measurement method, it was difficult to research the influences of soil specimen deformation caused by end restraint and end contact in triaxial test before.
8. 用三维激光多普勒测速系统测量研究了一个离心压气机转子近端壁区三维紊流流场。
Three-dimensional turbulent flow of the endwall region inside a centrifugal compressor impeller was studied using a Laser Doppler Velocimetry.
9. 目的:通过CT三维重建正常中国人股骨近端大体形态,测量29个解剖参数,为选择、设计假体提供解剖学依据。
Objective: to obtain 29 anatomic parameters of normal Chinese proximal femur through ct 3d reconstruction so as to provide anatomical references for hip prosthesis selection and design.
10. 目的:通过CT三维重建正常中国人股骨近端大体形态,测量29个解剖参数,为选择、设计假体提供解剖学依据。
Objective: to obtain 29 anatomic parameters of normal Chinese proximal femur through ct 3d reconstruction so as to provide anatomical references for hip prosthesis selection and design.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
