
词语导航
基本信息
词语:胶层
繁体:膠層
拼音:jiāo céng
英语翻译
sub
相关词条
1.gluefilm 2.glueline 3.bondline 4.substratum 5.sabstratum分词翻译
胶的英语翻译:Www.WeNtIYI.cOM
glue; gluey; mucus; pastern; sticky【医】 gloea; glue
层的英语翻译:
layer; region; stage; story; stratum; tier【计】 layer
【医】 coat; lamella; lamellae; lamina; laminae; layer; strata; stratum
翻译例句
1. 热的作用使布上胶层进行硫化。
The role of heat to the cloth layer for curing.
2. 充金箔:面上有胶层和金漆的铝箔。
Imitation gold foil: Aluminium foil with gold lacquer on plastic carrier.
3. 充银箔:面上有胶层和透明漆的铝箔。
Imitation silver foil: Aluminium foil with clear lacquer on plastic carrier.
4. 内胶层:耐油合成橡胶。
Inner Tube: oil resistant synthetic rubber.
5. 导电胶膜具有一离型层与一异方型导电胶层。
The conductive film is provided with a release layer and an anisotropic conductive film.
6. 两层细胞(两胚层),中间是凝胶状的中胶层。
Two cell layers (diploblastic) separated by a gelatinous mesoglea.
7. 提出了一种计算含裂粘补结构胶层剪应力的新方法。
A new method is developed to determine the shear stress between cracked panel and the patch which mends the crack of the panel.
8. 通过胶层材料的疲劳性能实验曲线拟合得到损伤演化参数。
The parameters of glue damage development were obtained by the fitting curves of fatigue experiments.
9. 基材与胶层结合力大,在存放或施工过程中不存在脱胶现象。
Bonding force of substrate and adhesive layer is large. No adhesive failure occurs during storage and construction.
10. 充金箔:面上有胶层和金漆的铝箔。烫印书籍封面和其他装饰用。
Imitation gold foil: Aluminium foil with gold lacquer on plastic carrier. Used for blocking the covers of books and other decorations.
11. 结构:胶管由内胶层、一层两层或三层钢丝编织层和外胶层组成。
CONSTRUCTION:This hose consists of an inner tube of oil synthetic rubber, wire braids reinforcement, and an oil and weather resistant synthetic rubber cover.
12. 另外,本文还利用时域有限差分法分析了光刻胶层内部的光场分布。
In addition, the distribution of light fields in the photoresist layer is analyzed by finite-difference time-domain method.
13. 得到了散射电子在电子束胶层中背散射与前散射的能量沉积分布图。
The graphs of the forward scattering energy deposition and backscattering energy deposition have been given.
14. 持粘性也受胶层厚度影响较明显,但基材厚度和材质对其影响不大。
The holding power also had relationship with adhesive thickness, but almost had no relationship with substrate thickness and substrate types.
15. 充银箔:面上有胶层和透明漆的铝箔。烫印书籍封面和其他装饰用。
Imitation silver foil: Aluminium foil with clear lacquer on plastic carrier. Used for blocking the covers of books and other decorations.
16. 结构:由内胶层、内胶保护层、中胶层、钢丝缠绕层和外胶层组成。
CONSTRUCTION: It is composed of an inner rubber protection layer, middle rubber layer, steel wire spiral layer and external rubber cover.
17. 在加热过程中,胶层粘度随温度和时间的变化可用二重指数方程描述。
The viscosity change of a glue line with temperature and time could be described qualitatively by a dual equation.
18. 所研制的透湿防水胶布的结构组成为覆盖胶层、底涂胶层和纺织物层。
The proposed moisture-permeable and water-proof rubberized fabric consists of coating, substrate and textile.
19. 计算和讨论了胶层的热传导率、厚度对激光破坏阈值及热恢复时间的影响。
The effects of heat conductivity and thickness of glue on laser damage threshold and heat recovery time are calculated and discussed.
20. 中间胶层可减低太阳辐射,有节省能源、降低噪音、防止室内设施褪色的性能。
Middle PVB film layer reduces sun radiation, with the features of energy-saving, noise reduction and protecting indoor things from fading.
21. 以往试验结果与工程实践表明,一般以胶层与混凝土之间的结合环节最为薄弱。
Formerly the test result and the project practice indicated that generally conglutination between the adhesive layer and the concrete is weakest.
22. 采用弧形外缘的轴承可以减小胶层间应力的急剧变化,能够延长轴承的使用寿命。
The dramatic changes of node stresses between rubber layers were decreased in the bearing with an arc profile, which could improve the life of the elastomeric bearing.
23. 一种充气轮胎,其中至少胎面部(3)的轮胎外周侧部分由非导电胶层(12)构成。
A pneumatic tire where at least an outer peripheral portion of the tread (3) is constructed from an electrically nonconductive rubber layer (12).
24. 通过改变反应气体的比率或成膜输出,可以使无机光刻胶层的氧浓度在厚度方向不同。
The oxygen concentration of the inorganic resist layer can be varied along the thickness direction by changing the proportion or film formation output of reactive gas.
25. 用热机械分析(TMA)方法研究了三聚氰胺-尿素-甲醛树脂固化初期胶层粘度的变化。
Viscosity change of melamine urea formaldehyde glue line was investigated with a thermo mechanical analyzer (TMA) used as a parallel plates rheometer.
26. 本实用新型涉及一种七段显示器的发光结构,包括有一基板、多个发光芯片及一透光胶层。
The utility model relates to a luminous structure of a seven-segment display, including a substrate, a plurality of luminous chips and a light transmission glue layer.
27. 本文研究内容可以为建立考虑胶层厚度影响的粘砂套管固井质量评价修正方法提供理论基础。
This article can provide the theory base for establishing the cementing quality evaluation method of adhering sand casing with considering the effect of glue layer thickness.
28. 其特征是在组合钢板构件连接部位或加强部位,用胶层将另一块所需的钢板胶接在钢构件上。
It is characterized in that another steel board is glue connected on the steel component at the location of the built-up steel board connecting location or the enforcing location.
29. 压花刀具与多个圆盘刀同轴设置,且用以在条状导电胶膜上的异方性导电胶层形成多条凹槽。
The knurling tool is arranged around the same axis with the cutter disks and used for forming a plurality of grooves on the anisotropic conductive film of the strip-shaped conductive films.
30. 压花刀具与多个圆盘刀同轴设置,且用以在条状导电胶膜上的异方性导电胶层形成多条凹槽。
The knurling tool is arranged around the same axis with the cutter disks and used for forming a plurality of grooves on the anisotropic conductive film of the strip-shaped conductive films.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
