固化程度用英语怎么说,固化程度的英文翻译


词语导航

基本信息

词语:固化程度

繁体:固化程度

拼音:gù huà chéng dù

英语翻译

【化】 degree of cure

分词翻译

固化的英语翻译:

solidify
【计】 hardening
【化】 cure; curing
【医】 solidification; solidify

程度的英语翻译:

degree; extent; grade; measure; pitch; tune
【医】 Deg.; degree; level
【经】 degree; extent

翻译例句

1. 结果表明,ATPU的含量对固化放热特征,放热量和固化程度等有显著的影响。

The results showed that the amount of ATPU curing agent have an obvious influence on the curing reaction heat and curing degree.

2. 而且随着固化温度的提高,胶粘剂体系的固化速度和固化程度还会进一步增加,力学性能、粘结性及耐热性能也会进一步提高。

As the hardening temperature increases, the speed hardening and degree of the adhesive JD increase, the mechanical and adhesion performances of the adhesive systems can be further improved.

3. 研究了混入不同着色剂的液态光敏树脂在激光扫描照射下树脂单层固化厚度的变化规律,比较了不同着色剂对树脂固化程度的影响。

To compare the impact of coloring agents on resin curing, the experiment was carried out to study the curing layer depth of resin mixed with different kinds of coloring agents under laser scanning.

4. 重涂时间的间隔,由施工时的温度和涂膜固化的程度(以手触不粘)来确定。

The interval of the coating time is determined by the temperature at the time of construction and the degree of curing of the film (by hand).

5. 光固化树脂充填后可能出现不同程度的牙髓反应。

The dental pulp reaction will appear in different degree after the light curing composite is filled.

6. 固化涂膜反射光线的程度。

The degree of reflection of light from the cured film.

7. 不同的环氧固化体系的性能存在较大差异,改性材料的种类和用量对结构胶的性能也存在不同程度的影响。

There is great difference in the performance among the different epoxy curing system, the kinds and the contents of the modified components have influence on the performance of the adhesive.

8. 第二、三两章分别从词序凝固化、小句整合两个方面,也就是从连动式的内部、外部证明连动式是句法化程度较低的句法结构。

The second and the third parts of this thesis demonstrate that the SVCs are on a lower level in grammaticalization, which can be seen by the constraints of word order and clause integration.wWw.WENtIYI.COM

9. 预固化可使氰酸酯树脂发生一定程度的自聚反应,从而降低其流动性,可明显改善氰酸酯树脂的工艺性,提高了层板的成型质量。

The precure process makes the resin cure to a certain extent, decreases resin flowability, improves resin processability significantly, and enhances the composite laminates quality.

10. 当反应程度达到60%左右后,由于交联程度增加,分子质量迅速增大,分子间扩散较慢,进入反应的第二阶段,主要由扩散作用控制固化速率。

When the curing extent was about 60 percent, the molecular weight raised rapidly and diffusion control was incorporated to describe the cure in the latter stages.

11. 结论:与单纯光固化复合树脂相比,经过二期处理的光固化复合树脂,其径向抗张强度和硬度不同程度的提高。

Conclusions: the diametral tensile strength and hardness of the secondarily treated composite resins were higher than those of the light cured composite resins.

12. 以液体聚硫聚脲齐聚物来增韧环氧-聚酰胺体系,用DMTA和SEM研究了固化后环氧树脂的形态结构、相分离程度和增韧效果。

The measurement of DMTA and SEM was used to study the morphology and structure of the cured epoxy, identifying the degree of phase segregation and the effect of toughening in the cured epoxy.

13. 主要反映在对涂层材料、涂层结构、表面处理工艺、热固化工艺等设计的理解深度和重视程度上。

Those mainly reside in understanding depth of and attention level to the coating material, coating structure design, surface cleaning process and heating drying process.

14. 因此,通过改变固化温度和聚醚酰亚胺的端基来降低聚醚酰亚胺的表面能,可以在一定程度上调控反应诱导相分离体系的相结构,并获得相间距较小的双连续结构。

It suggests that the phase structure can be controlled by lowering the surface energy of polyetherimide and it is a possible way to obtain co-continuous structure with a smaller periodic distance.

15. 树脂的互穿程度直接受初始固化温度的控制。

The interpenetrating degree was controled by the thermosetting temperature.

16. 当你对拼合的合适程度满意之后,在榫头和榫槽上都涂上胶水,将榫卯拼接起来并用夹钳夹好直到胶水固化。

Once you"re satisfied with the fit, apply glue to all the mating surfaces, and slide the pieces together. Clamp the assembly securely until the glue has dried.

17. 在满足尾砂泵送能力的前提下,最大程度地提高尾砂的浓度可以有效减少水泥用量,降低固化成本。

Under the prerequisite of satisfying the pumping capacity of tailing, the possible highest tailing concentration can effectively reduce the cement consumption so as to decrease the solidifying cost.

18. 对两类粘土固化浆液从无侧限抗压强度和塑性强度两个方面进行了研究,分析了各主要因素对强度的影响程度。

The unconfined compressive strength and plastic strength of two kinds of hardening clay-based grout has been studied. It was analyzed how the main composition content affected the strength.

19. 对两类粘土固化浆液从无侧限抗压强度和塑性强度两个方面进行了研究,分析了各主要因素对强度的影响程度。

The unconfined compressive strength and plastic strength of two kinds of hardening clay-based grout has been studied. It was analyzed how the main composition content affected the strength.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!