阀套用英语怎么说，阀套的英文翻译

词语导航

基本信息

词语：阀套

繁体：閥套

拼音：fá tào

英语翻译

【化】 valve cover

相关词条

1.valvepocket  2.valvejacket  3.valvecover  4.valvebush  

分词翻译

套的英语翻译：

convention; copy; cover; formula; harness; knot; series; set; sheath; sleeve
suit
【化】 covering; set
【医】 set

翻译例句

1. 单向阀由单向阀套、阀芯、阀座和弹簧构成。

The unidirectional valve comprises a unidirectional valve sleeve, a valve core, a valve seat and a spring.

2. 油温升高使阀心受热膨胀，阀套与阀心间的配合间隙减小， 阀心有可能被卡死在阀套里。

The fit clearance between spool and sleeve decreases because of the thermal expansion of the spool caused by temperature increment, so it is possible that spool is deadlocked in sleeve.

3. 回转接头的阀芯和阀套经重新设计和改造后，简化了工艺，降低了成本，为国家节省了大量外汇。

Through the redesign and revamp of the valve disk and body of rotary spindle, the technology is simplified, the cost is reduced and a large amount of foreign exchange is saved for our country.

4. 滑阀是由阀芯和阀套两部分组成，通常用作电液伺服阀的功率放大级，其精度要求高，加工难度大。

Spool valve is composed of valve spool and valve sleeve, and as the power stage of servo valve, it has a high degree of accuracy and is difficult for machining.

5. 通过对锥阀特性的分析，设计了一种阀芯、阀套同时运动的芯套双动高速开关阀，该阀增大了高速开关阀的开口度，提高了响应速度和流量。

To improve the response speed of on-off solenoid valve of big flux, detailed analysis on poppet valve is given and an on-off solenoid valve with movement of both spool and cover is designed.

6. 高速电磁开关阀存在大流量与高速响应之间的矛盾。通过对锥阀特性的分析，设计了一种阀芯、阀套同时运动的芯套双动高速开关阀，该阀增大了高速开关阀的开口度，提高了响应速度和流量。

To improve the response speed of on-off solenoid valve of big flux, detailed analysis on poppet valve is given and an on-off solenoid valve with movement of both spool and cover is designed.

7. ZSFL预作用装置是在本公司生产的雨淋报警阀出水口上端配接一套同规格的湿式报警阀构成的预作用报警装置。

The ZSFL Pre-action Alarm System is made by equipping the top of the outlet of the deluge alarm valve with a wet-type alarm valve of the same size.

8. 当使用一套液压提升集时，那么一个提供液压动力的方向控制阀是必需的。

When a set of Hydraulic Elevators are used, then a hydraulic supply from a directional control valve is required.

9. 该阀采用环空外压操作测试阀的开关，不需要保压，而且采用简单的机械压力平衡机构代替了专用计量套。

Without keeping annulus pressure to static and instead of special metering by simple mechanical pressure ba lance structure, this valve is conducted by annulus pressure.

10. 某油田一天然气井的产量突然下降，经检查发现该井采气装置中的节流阀柱塞套断裂为三截，形成了两对断口。

The yield of a natural gas well in an oilfield dropped suddenly, which was due to the piston sheath of the choke valve breaking into three parts with two pairs of fractures after inspection.

11. 本文介绍利用8031单片机控制步进电机及微型电磁阀而实现的一套自动变换药液装置。

The article reports a kind of automatic device using 8031 single chip microcomputer for the control of a stepping motor and small electromagnetic valves.

12. 通过对精密加工件分配阀体主阀孔的加工工艺试验及研究，总结了一套行之有效的加工工艺。

A complete processing technology is summed up for the main valve opening of the dividing control valve in the fine machining pieces based on the study and test.

13. 试验表明，钻井泵泵阀和缸套经增碳-钒化处理后其使用寿命显著延长。

Test shows that the service life of the drill pump valve and liner after carburizing and vanadiumizing are greatly extended.

14. 氯丁橡胶管套，即插即用存储附件，咬阀盖。

Neoprene tube cover, plug-n-play reservoir attachment, bite valve with cover.

15. 暖通空调(HVAC)系统中建立一套对各种水阀、风阀、变风量箱、电加热器、加湿器以及其他控制元件进行准确测量及时控制的数据采集控制系统。

Builds a suit of HVAC DAQ and control system which could take precise data acquisition and control water valve, air valve, VAV box, electrical heater, humidifier and other control elements.

16. 以测试冻土冻胀的力学行为为研究背景，设计了一套基于阀控非对称缸的液压力控制系统。

By regarding testing mechanics behaviors of frozen soil frost heave as the research background, a hydraulic force control system was designed on the basis of valve control asymmetric cylinder.

17. 本文介绍了生产阀簧钢丝的一套热处理新技术。

In this paper we introduced a new technique of heat treatment for producing valve spring wires.

18. 截止阀的柔性元件的径向变形值可以调节，保证柔性螺纹套的环槽与螺杆上的螺纹的接合深度。

Radial distortion of the flexible component in the stop valve can be adjusted so as to ensure the joint depth between flexible screw thread trepanning circular groove and screw thread on the screw.

19. 泵的置有吸入阀和排出阀、泵缸、缸套和拉杆的一侧。

The side of a pump where the suction and discharge valves, pump cylinders, liners, and rods are located.

20. 气体分流管将阀连接到滑封隔膜套。

A drop-leg pipe connects the valves to the dead-headed diaphragm housing.

21. 本发明是在原有的泵油装置中，增加一套由三能阀及喷管等组成的加热罐内部循环回路。

An internal circulation loop of heating tank composed of three-function valve and jet tube is added in original pump arrangement.

22. 对壳管式换热器、螺杆压缩机、电子膨胀阀进行详细的选型和设计计算，对哈尔滨市某办公楼设计出一套污水源热泵系统。

Shell and tube heat exchanger, screw compressor, and electronic expansion valves are detailed selectioned and designed, and a sewage-source heat pump system is designed for a building of Harbin.

23. 本文介绍了一套燃油蒸发排放控制系统(EECS)，此系统主要包括炭罐、清洗阀、油气分离器、翻车阀等。

In this paper, an EECS (Evaporation Emissions Control System), which includes the canister, purge valve, vapor-liquid separator, rollover leakage protection valve, is designed and tested.

24. 设计了一套专门用于控制多级节流管汇液动平板阀的控制系统，主要目的是为多级节流系统在压井过程中实现自动控制奠定基础。

A control system which USES to control the flat valve of multistage throttle is design in order to establish the foundation for automatic control of multistage throttle during press the well.

25. 套、立压表、阀位开度表、气压表、油压表等组件组成。 还有气动压力和阀位变送器。

The cover, the vertical pressure meter, the valve position opening scale, the pressure gauge, the oil pressure gauge and so on.

26. 如在阀体外加上外冷却夹套，则可进一步降低对阀材料的要求。

If an external cooling jacket is used, the requirement on valve material can be further reduced.

27. 曼理为上海某公司提供的液压动力单元，集成了曼理泵，阀和阀块等。是曼理公司第一套自行设计，生产的液压动力单元。

Hydraulic power station for Shanghai COMPANY integrate Marlin pump and valve and manifold, which is Marlin design, manufacture hydraulic power station.

28. 本发明提供一套自力式机械装置、自动调节活动堰板、反冲阻流器、提拉阀。

This invention provides a set of self-powered mechanical device, an auto-regulating movable weir-plate, a back-flushing buffer and lift-pull valve.

29. 大气量时应用偏心气锚安装气举阀与地面单流阀两步卸气，实现了下部产层和油套环空自动卸气。

Ortherwise, the eccentric gas anchor, gas lift valve and surface check valve are installed to automatically unload the gas from the deeper layer and annulus between the tubing and the casing.wWW.WENtIYi.cOM

30. 大气量时应用偏心气锚安装气举阀与地面单流阀两步卸气，实现了下部产层和油套环空自动卸气。

Ortherwise, the eccentric gas anchor, gas lift valve and surface check valve are installed to automatically unload the gas from the deeper layer and annulus between the tubing and the casing.