
词语导航
基本信息
词语:过热处理
繁体:過熱處理
拼音:guò rè chǔ lǐ
英语翻译
【机】 super heating
分词翻译
过的英语翻译:
across; cross; excessive; over; pass; spend; through
【医】 per-
热处理的英语翻译:
heat treatment
【化】 heat treating; heat treatment; thermal treatment
翻译例句
1. 橄榄色人造绿堇云石通过热处理产生。
Prasiolite, an olive-colored material, is produced by heat treatment.
2. 这些零件已全部经过热处理。
All these parts have been heat treated.
3. 通过热处理改变碳钢试件的晶粒尺寸。
The grain sizes of test parts were changed by heat treatment.
4. 零部件经过热处理,强度高,耐磨性好。
Components are under heat treatment. high impact and good abrasion resistance.
5. 这种合金能通过热处理获得良好的综合机械性能。
The combination of mechanical properties of this alloy can be well achieved by heat treatment.
6. 目前所有血液制品均经过热处理,以防止各种感染。
All blood products are now heat treated to kill off any infection.
7. 经过热处理后,板材的断裂模数变小,而含尘量增加。
Heat treated boards display a reduced modulus of rupture and an increase in dustiness.
8. 工件头架由经过热处理、具有高尺寸稳定性铸铁铸造。
The headstock body is made of highly resistant thermally stabilized cast iron.
9. 熔体过热处理是细化组织提高合金力学性能的有效途径。
Molten melt superheat treatment is an effective means for microstructure refinement and advancement of alloy mechanical property.
10. 设备工作台由经过热处理、具有高尺寸稳定性铸铁铸造。WwW.weNTiYi.CoM
All tables are made of highly resistant thermally stabilized cast iron.
11. 介绍了通过热处理提高白口铸铁硬度和韧性的试验结果。
This paper highlights the experiment results in improving the toughness and hardness of white cast iron by heat treatment.
12. 硬坯:是已经过热处理的、准备磨加工的滚子、内圈或外圈。
HARDSTOCK: the rollers, cups, or cones, which have gone through the heat treat process and are ready for grinding.
13. 通过热处理手段获得可区分晶粒尺度和片层厚度的全片层组织。
The fully lamellar microstructures with different grain size and lamellar spacing were obtained by heat treatment.
14. 通过热处理可提高轨钢的强度及硬度,接触疲劳强度也随之提高。
Heat treatment can increase the tensile strength and the hardness of the rail steel, and the contact fatigue strength is also increased.
15. 研究了熔体过热处理对M963铸造镍基高温合金凝固偏析的影响。
The effect of melt overheating treatment on the solidification segregation of M963 cast Ni-base superalloy has been studied.
16. 然后,如果有需要,这些管子将经过热处理或者直接进入质量测试环节。
Then, if needed, the pipe undergoes heat treatment or just goes to the quality testing line.
17. GBL还能够凝集正常的枯草芽孢杆菌和经过热处理的酿酒酵母细胞。
GBL also agglutinated natural cells of Bacillus subtilis and Saccharomyces cerevisiae treated by heating.
18. 不同金属的热处理过程都不一样,并且在出厂之前厂家已经经过热处理。
Heat treating the metal parts is a very different process, and it"s already done at the factory before the engines are assembled.
19. 定购这些产品时,可以要求在制造流程之后通过热处理方法除去有机粘合剂。
These products may be ordered with the organic binding agents already removed by heat treating following the manufacturing process.
20. 一些高铬钢能通过热处理硬化,可用于抗磨坏,抗磨损,抗腐蚀需求的地方。
Some high chromium steels can be hardened by heat treatment and are used where resistance to wear, abrasion, and corrosion are required.
21. 自然通风的立面采用的是未处理的落叶松木材,而屋顶由经过热处理的松木组成。
The ventilated facade is finished with planks of natural larch wood and the roof with heat-treated pine wood.
22. 具有马氏体基体的高铬铸铁,有理想的耐磨组织,但通常要通过热处理才能得到。
However, the martensitic matrix of high-chromium cast iron has excellent abrasion-resistant tissues, which used to be obtained only by means of heat treatment.
23. 通过热处理实验,探讨长庆外输原油最优热处理条件及影响热处理效果的有关因素。
The optimum conditions for heat treatment of Changqing output crude and some factors concerned affecting the effect of heat treatment are approached through heat treatment experiment.
24. 元件在烧结后,经过热处理和电老练,其性能较传统的固相球磨制备元件提高很多。
After being sintered and the heat treatment and electricity treatment, the performance of these varistors was superior to that of the varistors fabricated by the solid phase method.
25. 试验结果也表明,过热处理或热处理不足,都对“双低”菜籽饼粕质量产生严重影响。
It suggested that either overheated or under-heated processing be critical for the quality of double-low rapeseed meal.
26. 特殊的材料包括球墨铸铁和钢煅品,大部分机轴经过热处理,表面硬化、渗氮和感应淬火。
Typical materials include ductile iron castings or steel forgings. Most crankshafts require some form of heat treating including case hardening, nitriding and induction harden.
27. 选用三种不同碳、铬含量的耐磨钢,通过热处理获得不同数量的二次碳化物和马氏体基体。
The effects of varying the amount of secondary carbide on the character of matrix under three-body abrasion of wear resistant steel have been investigated.
28. 选用三种不同碳、铬含量的耐磨钢,通过热处理获得不同数量的二次碳化物和马氏体基体。
The effects of varying the amount of secondary carbide on the character of matrix under three-body abrasion of wear resistant steel have been investigated.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
