喷动床用英语怎么说,喷动床的英文翻译


词语导航

基本信息

词语:喷动床

繁体:噴動床

拼音:pēn dòng chuáng

英语翻译

【化】 spouted bed

分词翻译

喷的英语翻译:

gush; spew; spout; spray; sprinkle; spurt

动的英语翻译:

act; move; stir; use
【医】 kino-

床的英语翻译:

bed; fleabag; kip
【医】 bed; clino-; matrix

翻译例句

1. 喷动床是处理粗颗粒物料的高效反应器。

Spouted bed is an efficient reactor for handling the coarse particle materials.

2. 对于工业规模喷动床设计,具有一定的参考价值。

It is a referential use for the design of spouted bed in commercial scale.

3. 提出了一种新型的喷雾-喷动床半干法烟气脱硫技术。

A new semi-dry desulfurization using spray spouted bed was introduced in the paper.

4. 矩形喷动床的流体力学性能及脱硫性能优于柱锥型喷动床。

Rectangular spouted bed had better hydrodynamics and desulfurization characteristic than conical-cylindric spouted bed.

5. 常规喷动床直径放大因受到喷动原理限制存在一定的困难。

It is difficult to scale up conventional spouted bed in diameter because of the limit of its operational principle.

6. 本文叙述了一种适合于颗粒涂覆用的,具有特殊的多气体入口的喷动床。

Here a kind of spouted bed with multi gas inlets for fuel particles "coating is described.

7. 结果表明:稀相喷流床中环隙区颗粒的下降速度比传统喷动床高出一个数量级;

The results show the particle velocity in the annulus area in this equipment is about an order of magnitude higher than that in ordinary spout-fluid beds;

8. 实验表明,双喷嘴矩形喷动床的最小喷动速度与颗粒粒径、床层高度及操作温度有关。

The experiment shows that the minimum spouting velocity was related to the particle sizes, bed height, and operational temperatures.

9. 为研究“新型旋转导向管喷动床”的性能,采用油菜籽为原料,进行了流体动力学试验。

To study the performance of Spouted Bed with Rotating Draft Tube (RDTSB), the rapeseeds were taken as raw material for carrying out the fluid dynamics experiment.

10. 在综合考虑各影响因素的基础上,得出了双喷嘴矩形喷动床最大喷动压降的经验关联式。

On the basis of these factors, an empirical equation for the maximum pressure drop was determined.

11. 在双喷嘴矩形喷动床内,以空气为喷动气体,研究了最小喷动速度的变化规律和影响因素。

The change laws and influential factors of the minimum spouting velocity of a rectangular spouted bed with double nozzles were studied with air as spouting medium.

12. 本文结合喷动床流态化技术和喷雾干燥法提出了一种新型喷雾—喷动床半干法烟气脱硫系统。

A new semi-dry desulfurization technique using spray spouted bed was proposed which connected with fluidization of spouted bed and spray-drying technique.

13. 对无导流管矩形喷动床与导流管矩形喷动床及柱锥形喷动床的流体力学性能和脱硫性能进行了对比。

Hydrodynamics and desulfurization characteristic were compared for rectangular draft tube spouted bed and rectangular spouted bed and conical-cylindric spouted bed.

14. 在双喷嘴矩形喷动床内,以空气为喷动气体,研究了最大喷动压降与操作压降的变化规律和影响因素。

The maximum pressure drop and the operational pressure drop were investigated in a rectangular spouted bed with double nozzles by using air as spouting fluid.

15. 针对环形喷动床采用旋转锥播料器对环形空间给料的方法,研究喷动风速和床上物料量对颗粒混合规律的影响。

Aiming at rotating cone feeders used in annular spouted beds, the influence of spouting air velocity and the amount of hold-ups on particle mixing has been investigated.

16. 阐述了喷动流化床的结构、计算及特点。并介绍了典型喷动床和DOU、QUA TT RO喷动床及其应用。

The structure, calculation and characteristics of spraying and dynamic flowing bed were described. Meanwhile, the typical flowing bed, DOU bed and QUATTRO bed and their application were introduced.

17. 并在综合考虑床层高度以及气体和固体颗粒的物性的基础上,得出了双喷嘴矩形喷动床最小喷动时雷诺数的经验关联式。

Based on a comprehensive consideration of the bed height, and physical properties of air and solid particles, the experiential formula of Reynolds of the rectangular spouted be...

18. 其装置由风机、可燃气体源、燃烧器、加料器、喷动床、旋风分离器、静电除尘器、冷凝器及流量计、温度计、控制装置等组成。

Its equipment is formed from fan, flammable gas source, combustor, feeder, spouted bed, cyclone separator, static dust-remover, condensator, flowmeter, thermometer and control device.

19. 本文通过采用实验和数值模拟的方法,研究了喷动流化床内气体混合特性以及床内气固两相的流动特性。

The dissertation studies the characteristics of gas mixing and the gas-solid two phases flow in spouted-fluidization bed with experiment and numerical simulation methods.

20. 研究结果表明:在合适的喷动风和流化风配比下,可实现深床气化,使气化反应基本达到化学平衡;

Study results show that gasification can proceed deep in the bed and the gasifying reaction can approach chemical equilibrium at a proper ratio of spouting to fluidizing air.

21. 在一个加压喷动流化床装置上进行了冷态实验,研究加压条件下床中的气固流动状态和气体在各部分的扩散特性。

The experimental study of a gas solid flow pattern and gas diffusion characteristics using polystyol particles and glass bead has been carried out in a pressurized spouted fluidized bed.

22. 采用离散元方法,对喷动流化床内的颗粒混合特性进行了三维直接数值模拟。

Numerical simulations on particle mixing characteristics of spout-fluid bed were carried out in three dimensional based on discrete element method (DEM).WWW.WENTiyI.cOm

23. 本文对导向喷动流化床中固体颗粒的破损进行了理论分析和实验测试。

Theoretical analysis and experimental works have been carried out to study the solid particle attrition phenomena in a spouted-fluidized bed with a draft tube.

24. 该研究为喷动流化床的设计和结构优化提供了有价值的参考。

The research provided valuable reference for the design and structure optimization of spout-fluidized bed.

25. 研究了压力、静止床高及流化风对最小喷动速度的影响。

The influence of pressure, static bed height and fluidized air on the minimum spouting velocity was studied.

26. 测定了不同物料最大操作区所对应的静床高及喷动流化气速与床层压降、床层空隙率分布的关系。

The corresponding static bed height of the biggest spout fluid operating range and the relation between bed pressure drop and spout fluid velocity were determined.

27. 喷动流化床用于粉体造粒,是一种新型造粒方法。

Spouted fluidized bed is a novel powder granulator.

28. 喷动流化床用于粉体造粒,是一种新型造粒方法。

Spouted fluidized bed is a novel powder granulator.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!