阀管用英语怎么说,阀管的英文翻译


词语导航

基本信息

词语:阀管

繁体:閥管

拼音:fá guǎn

英语翻译

【电】 valve tube

分词翻译

阀的英语翻译:

clique; valve
【化】 valve
【医】 limen; limina; valve

管的英语翻译:

canal; duct; fistula; guarantee; meatus; pipe; tube; wind instrument
【化】 pipe; tube
【医】 canal; canales; canalis; channel; duct; ductus; salpingo-; salpinx
syringo-; tuba; tube; tubi; tubing; tubo-; tubus; vas; vaso-; vessel

翻译例句

1. 本文对油膜光阀管中电荷积累现象引起的图象扩大和红、蓝原色不能正确显示的原因进行了解释。

This paper explains the image expansion and confusion of the red and blue primary colours caused by the electric charge accumulation on the oil film in the colour TV light valve tube.

2. 汽车零部件、铁路件、压缩机类铸件、泵阀管类铸件、工程机械部件、农用机械部件、高空平台升降机部件等。

Automobile Components, Railway Castings, Compressors Components, Components of Pump, Valve and Pipe, Construction Machinery Parts, Agricultural Machinery Parts, Aerial Platform Parts etc.

3. 本发明公开一种用于输送液体的手动泵阀管,它是由一个手动波纹管或套筒活塞泵,分别同一个流量控制阀门组合为一体。

It is an integral entity which is made up of a manual corrugated pipe or sleeve piston pump and a flow controlling valve. It is suitable for liquid suction, pressing and siphoning.

4. 暗挖区间隧道通过采用超前探测、增设临时仰拱、袖阀管、锁脚锚管等技术措施,安全、顺利完成了北四环路和北辰桥段的施工。

By adopting some technology of advanced detection, adding temporary invert, sleeve valve pipe and lock foot bolts, the construction of the tunnel is completed safely and successfully.

5. 当钻井下沉时,海底立管在顶部附近破裂,另一端还连在防喷阀上。 在随后的倒塌中,它像脆饼一样弯曲。

When the rig sank, the riser broke near the top while remaining attached to the blowout preventer at the bottom, bending itself like a pretzel in its subsequent collapse.

6. 那时Q 4000会控制连接阻塞管和压井管到油井的真空阀。

The Q4000 will then have control over the valves that connect the choke and kill lines to the well proper.

7. 威尔士先生称,一旦控制板已经重新被安装在防喷阀上,管汇连接在Q 4000后,就要实施灭顶法了。

Mr Wells says that once the control pod has been reinstalled on the blowout preventer and the manifold is attached to the Q4000, the top kill could start.

8. 仪器由一个已知体积的球管和一个阀组或管网所组成。

The apparatus consists of a bulb of known volume and valve block or manifold.

9. 在安装夹管阀时,如果采用橡胶、PVC或任何“光滑的”配套法兰,则我们建议在两个法兰之间加装一个金属锯齿垫圈以增强密封效果。

When installing a pinch valve to a rubber, PVC, or any "slick" mating flange, we recommend that you install a metal serrated gasket between the two flanges to assist in the seal.

10. 套管的弹性运动可以碎裂淤积在阀门内的任何沉淀物,这使得A型夹管阀成为一款可靠的低维护的阀门。

The flexing action of the sleeve breaks up any sediment or build-up in the valve, which makes the Type a a reliable low-maintenance valve.

11. 美国红阀公司出品的A型无故障系统700从热储系统里提供气压,一个这种供气系统可以同时操作几个夹管阀。

The Type A fail-safe system 700 from Red Valve is sized to provide air pressure in the reservoir system to operate multiple valves from one reservoir.

12. 浮标的向上运动则产生吸力,可将阀球提起,这样可允许气流受力并返回至配重管。

Upward motion of the buoy causes a suction which lifts the balls, thus allowing air to be drawn back down the counterweight tube.

13. 美国红阀公司完整的压力传感器和夹管阀产品系列,能够满足用户的精确流体控制和特殊应用的要求。

Red Valve"s complete product line of Pressure Sensors and Pinch Valves are designed to meet our customer"s exact flow requirements and specific applications.

14. 型夹管阀采用的纯树脂橡胶具有优异的抗磨损能力,因为A型夹管阀只是采用气压进行操作,因此没有活动部件会断裂或磨损。

The pure gum rubber sleeve of the Type A Valve offers excellent abrasion resistance, and since the Type A uses only air pressure to operate, there are no moving parts to break or wear out.

15. 定时装置随后开启下面的夹管阀并持续一段固定的时间,让塑料粉末从中间罐腔中排出。

The timer then opens the lower valve for a fixed period of time, permitting the - plastic powder to discharge from the intermediate chamber.

16. 连接通向地漏的排泄管的美国瓦茨气隙的安装将有助于处理通过安全阀排出的任何正常排放或有害的泄漏。

The installation of a Watts air gap with the drain line terminating above a floor drain will handle any normal discharge or nuisance spitting through the relief valve.

17. 两个美国红阀公司夹管阀加上控制装置的成本远远低于其他控制方案。

The cost of two Red Valves with control equipment is considerably less than other control methods.

18. 这些部件是在压力下硫化并形成压力套管,这是夹管阀的心脏部分。

These parts are vulcanized under pressure to form a pressure-containing sleeve that is the heart of a Pinch Valve.

19. 如向上泵送则必须先关闭截止阀,防止砼倒流,然后拆下出料管。

Such as pumping up you must turn off valve to prevent backflow of concrete, then removed the feed tube.

20. 在安装系列4700夹管阀时,建议在阀门法兰后面采用镀锌钢支撑环加固。

When installing the Series 4700, it is recommended that galvanized steel back up rings be used behind the valve flanges.

21. 关闭分配阀卸料门,如有截止阀则打开,泵送清水至活塞从输送管输出端泵出为止。

Close the door distribution discharge valve and, if cut-off valve is opened, pumping water to the piston from the pipeline until the pump output.

22. 除了优异的抗研磨特性以外,如果石灰固化,A型夹管阀还能够通过驱动套管将固化石灰轻易清除。wWw.WENtiyi.CoM

Other than its excellent abrasion resistance, the Type A Valve can easily be cleaned if the lime solidifies, by actuating the sleeve.

23. 美国红阀公司的夹管阀套管结构类似于重型卡车的轮胎。

Red Valve Pinch Valve sleeves are constructed similar to a heavy-duty truck tire.

24. 造船工业。带自动阀的测深管测头。阀体详图。

Shipbuilding . head of sounding pipes with self - acting valve . details of body.

25. 在打开螺线阀之前,先将水倒入管中。

Water is poured into the pipe before opening the solenoid.

26. 美国红阀公司从1953年开始就向采矿业提供A型夹管阀。

The Red valve Company began by supplying valves to the mining industry in 1953 with the Type a valve.

27. 作为1号阀的替代品,美国红阀公司A型夹管阀和无故障气动系统700,也就是左图中的3号阀,极大地改善了流体介质的流动性。

As a replacement of valve number 1 with Red valve"s Type a and pneumatic fail-safe system 700, valve number 3 has accomplished an improvement in the fluid dynamics of the system.

28. 采用美国红阀公司A型夹管阀的优点很明显。

The advantages and features of using Red Valve Type A Valves are obvious.

29. 以A型夹管阀为基础改进而来,这种锚链管道阀门坚固耐用,使用寿命长,并配置内置气动执行器的气动夹管阀。

Modeled after the original Type A pinch valve, the valve is a rugged, long-lasting, air-operated pinch valve with a built-in actuator.

30. 以A型夹管阀为基础改进而来,这种锚链管道阀门坚固耐用,使用寿命长,并配置内置气动执行器的气动夹管阀。

Modeled after the original Type A pinch valve, the valve is a rugged, long-lasting, air-operated pinch valve with a built-in actuator.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!