预估控制用英语怎么说,预估控制的英文翻译


词语导航

基本信息

词语:预估控制

繁体:預估控制

拼音:yù gū kòng zhì

英语翻译

【化】 predictive control

分词翻译

预估的英语翻译:

【经】 estimate

控制的英语翻译:

control; dominate; desist; grasp; hold; manage; master; predominate; rein
rule
【计】 C; control; controls; dominance; gated; gating; governing
【医】 control; dirigation; encraty
【经】 check; command; control; controlling; cost control; dominantion
monitoring; regulate; rig

翻译例句

1. 介绍了模型预估控制的特点和基本算法。

Features of model predicting control and basic calculation methods were introduced.wWw.wEnTiYI.CoM

2. 史密斯预估控制;

Smith predictive control;

3. 本文将专家系统技术同预估控制方法相结合,得到了一种新的专家式控制方法。

This paper presents a new method of expert controller, which is gotten by means of combining the technique of expert system with predictor control.

4. 提出了一种大纯滞后系统新预估控制方法,对大纯滞后系统进行了有效的模糊控制。

This paper presents a new predictive control method for time-delay systems with long pure time delay, which effectively solved the control problem of them with fuzzy control.

5. 本文在第二章中分析了常规PID控制器的弊端和史密斯预估控制对模型的过度依赖问题。

In chapter 2, we analyse the the weakness of traditional PID controller and the over reliance of Smith predictive control on the model.

6. 特别是工业气相色谱分析仪表的应用对提升多变量预估控制的控制效果有着极其重要的作用。

Especially the application of industry gas chromatography has got very important action for the control results of multivariable predictive control.

7. 叙述了反再多变量预估控制器的设计目标、变量设计、动态数学模型、控制方案及实施策略。

The article describes design targets of multivariable controller, design variables, dynamic mathematical model and control strategies.

8. 采用内部模型控制、模糊预估器和模糊控制器相结合,对模糊内模预估控制方法进行了研究。

A predictive control method of fuzzy internal model is proposed. It adopts internal model control, fuzzy predictor and fuzzy controller which are combined together to act on the controlled process.

9. 并重点介绍了常减压蒸馏装置多变量预估控制器、软仪表的设计方法,DCS接口通讯及工程实施要点。

It introduces the design methods of multi-variable predictive control CDU and soft instrument, DCS communication interface and project realization of point.

10. 它综合了自适应预估控制在控制线性系统中的良好特性和神经网络在辨识、控制非线性系统中的高精确性。

The advantage of NN modeling accuracy and the good control performance of the optimal predictive control are combined.

11. 笔者提出:采用解耦算法,最优预估控制算法,以dsp为核心硬件,提高球团矿的合格率、抗压率、转鼓率。

The author puts forward: using uncoupling algorithm, optimal predictive algorithm based on DSP hardware, it can promote the percent of pass, bearing, rolling drum.

12. 对于带有严重纯滞后的工业对象,目前的控制策略是史密斯预估控制,或者是内模控制,他们都要使用连续域的数学模型。

For an industrial plant with high great lag, the current control strategy is Smith predictive control, or internal model control, both of them are using continuous models.

13. 为了更好地应用于时滞过程,利用无时滞psd系统渐近稳定的特点,提出了无预估模型的PS D自适应预估控制算法。

In order to apply well to the process with time delay, a model-free predictive control law for the PSD is proposed which scheme is based on the asymptotical stability in delay-free PSD system.

14. 通过系统状态预估及对状态运动的分析,设计了可以完全消除系统抖振的滑模控制器。

After state preestimate and state movement analysis, a discrete sliding mode controller which can essentially avoid the chattering phenomenon is designed.

15. 并对系统的响应进行预估,将对预估值和实际值进行比较计算并对实际控制量进行校正。

Estimate the response of the system, it will forecast and actual values calculated to compare the amount of actual control and correction.

16. 本文论述了一种预估模糊逻辑控制系统的工作原理和设计方法。

This paper presents the principle of a predictive fuzzy logic control system and the design method of it.

17. 介绍了汽油干点预估模型的建立过程、模型的验证及在线控制过程。

The establishment of predictive mathematical model of dry point of gasoline, verification of model and on-line control process were introduced.

18. 数字化逆变器的控制采用TMS320F 240芯片来实现,在其软件中采用了用于电流预估计的PI控制算法和电压电流的双环控制。

The digital inverter is controlled by a TMS320F240 DSP chip, which applying the improved digital PI control arithmetic of the current prediction and the double control loops of voltage and current.

19. 设计了甲醇合成过程的链预估算法和链控制系统。

The chain system prediction arithmetic and the chain control system were.

20. 针对广域信号存在时延的问题,提出一种基于史密斯预估器的附加励磁控制器设计方法。

To solve this problem, based upon unified Smith predictor (USP), a novel method for the additional excitation controller designing is presented.

21. 为此列举炼油装置的示例,介绍了两类预估先进控制经济效益的方法,即统计分析法和静态增益优化法。

Two categories of APC pre estimation methods are presented with examples relating to refining issues in this connection: statistical rules and the steady state gain optimization method.

22. 通过在烤漆生产线上的电阻炉的实验应用,显示史密斯预估位式调节器能有效抑制纯滞后造成的非线性位式控制系统的持续振荡,有效提高位式温度控制系统的控制精度。

Using the application on baking paint stove, it appears that smith prediction on-off controller can reduce the oscillation value of on-off control system and improve the accuracy effectively.

23. 给出了作为模型预估器的神经网络GA—BP算法流程及GA 算法实现,提出了最优控制指标选择原则及控制指标表达式。

The GA-BP learning algorithm of neural network, the GA learning algorithm, the rule of optimum control including their features were introduced.

24. 所以,建立高精度的发酵过程产物预估模型,就成为优化控制需要研究的核心内容。

Therefore, the establishment of high-precision prediction model of fermentation process products becomes core content to be researched in optimal control.

25. 本文主要针对太阳能光伏电池发电进行了研究,采用电流预估计算法和电流电压双环控制的方法提高逆变输出的电流电压波形;

This dissertation mainly research solar power generation, using the measure of current pre-estimative arithmetic and voltage double-loop control to improve the wave of output current and voltage ;

26. 本文方法可以用于预估单桩承载力及控制桩的打入深度。

The method can be used to estimate the bearing capacity…

27. 电弧炉和精练炉控制采用基于三相意识的专家控制系统,并提出一种新的电弧炉控制算法预估补偿算法。

The paper also presents a predictive compensation algorithm based on the neural network; the algorithm is used to predict the condition of E. A. F, by which the output of a routine c…

28. 电弧炉和精练炉控制采用基于三相意识的专家控制系统,并提出一种新的电弧炉控制算法预估补偿算法。

The paper also presents a predictive compensation algorithm based on the neural network; the algorithm is used to predict the condition of E. A. F, by which the output of a routine c…

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!