在管线内用英语怎么说，在管线内的英文翻译

词语导航

基本信息

词语：在管线内

繁体：在管線內

拼音：zài guǎn xiàn nèi

英语翻译

【化】 in-line

分词翻译

在的英语翻译：

be; depend on; exist; at; in
【计】 plot on X axis; search in

管线内的英语翻译：

【化】 in-line

翻译例句

1. 在高压试验或处理结束时，必须将处理管线和相关系统内的压力安全地放泄，以使能够继续进行以后阶段的作业。

At the conclusion of high-pressure tests or treatments, the pressure within the treatment lines and associated systems must be bled off safely to enable subsequent phases of the operation to continue.

2. 在高速公路的规划红线内和一级公路的快车道内，不得埋设地下管线。

No underground pipe-and-line-works shall be laid and buried within the planned red line of expressway and fast lane of Grade a highway.

3. 绝缘接头与管线连接后，不许在接头5米内起吊管线。

It is forbidden to lift pipe within 5 meters closed to the joint after insulation joint is connected to the pipe.

4. 分析表明：该管线的变形失效是在加套管过程中工艺安排不当所致，在施工过程的试压期间引起了内管的外压失稳，使内管产生永久的变形。

The impact of some key construction links on destabilization of the external pressure of the inner pipes was analyzed and verified in the course of pope-line rebuilding.

5. 腐蚀产物与注入水的结垢造成了管线的堵塞，并且注入水在储层内结垢是造成储层渗透率降低的主要原因。

Corrosion products and filth lead to pipeline jam, and scaling inside the reservoir is the most important reason.

6. 在管线下倾角较大的情况下，液塞长度分布集中在较小的范围内。

On the condition of a larger pipe inclination Angle, the distribution of liquid slug lengths was more concentrated in a smaller range.

7. 基于风险的管线完整性管理在全世界范围内得到应用。

Risk based pipeline integrity management programs were implemented by pipeline companied worldwide.

8. 在城市道路、公路的规划红线内进行管线工程建设的，管线位置的规划安排应当遵循下列规定。

When the construction of pipe-and-line-works is carried out within the planned red line of urban roads and highways, the position arrangement of pipe-and-line-works shall follow the provisions below.

9. 结果证明，盾构姿态、盾构千斤顶油压、下行线隧道位移、市政管线沉降等参数均控制在允许范围内。wWW.WeNTIyi.COM

Result shows that parameters are controlled in allowable range, such as shield posture, oil pressure of shield jacks, displacement of down link, settlement of municipal pipelines and so on.

10. 结果证明，盾构姿态、盾构千斤顶油压、下行线隧道位移、市政管线沉降等参数均控制在允许范围内。

Result shows that parameters are controlled in allowable range, such as shield posture, oil pressure of shield jacks, displacement of down link, settlement of municipal pipelines and so on.