
词语导航
基本信息
词语:容许度
繁体:容許度
拼音:róng xǔ dù
英语翻译
【电】 tolerance
分词翻译
容许的英语翻译:
admit; allow; allow of; permit; sufferance; tolerate
【计】 allowed
度的英语翻译:
consideration; tolerance; degree; limit; linear measure; surmise; estimate
extent
【计】 degrees; k.w.h.
【化】 dimension; kilowatt hour
【医】 Deg.; degree
【经】 degree
翻译例句
1. 张力错误一个错误被产生的容许度。wwW.wENTiYi.coM
Tension error tolerance beyond which an error is generated.
2. 机器将会被停止的容许度范围。
Tolerance range beyond which the machine will be stopped.
3. 错误指示和机器停止发生只有当是否如此的容许度在下个叁数中被为时间周期组超过。
The error indication and machine stop occur only if such tolerance is exceeded for the time period set in the next parameter(TIME TNESION).
4. 从体能方面来说,沙坑击球是高尔夫中最简单的击球,因为它对失误有最大的容许度。
Physically the bunker shot is the easiest shot in golf because it has the greatest margin for error.
5. 我所试验的精制橄榄油和2/3的特级纯橄榄油在容许温度450度时冒烟了。
The refined olive oil and two of three extra-virgin olive oils I tested began to smoke at a respectable 450 degrees.
6. 不过当密度、度和曲率到达某个弦论所容许的最大值时,这些量会反弹而开始变小。
But when the density, temperature and curvature reached the maximum values allowed by string theory, these quantities bounced and started decreasing.
7. 激光模块是安装在一个电动底座上,容许系统水平360度旋转。
The laser is mounted on a motorised base allowing for horizontal rotation in both directions.
8. 其有益于行驶稳定度并容许更快速的加速。
This increases driving stability and allows for much faster acceleration.
9. 安装搅拌器的设备口的法兰面同容器轴线的垂直度容许偏差为1/500。
The flange face of agitator mount nozzle shall be perpendicular to vessel axis within tolerance of 1/500.
10. 螺孔延伸有利于增加连接柔度,容许大变形的发生。
The elongation increased joint flexibility, allowing larger deformations without further fracture.
11. 文中还给出了对应于不同可靠度下的最大容许应力幅值。
Themaxium range of allowable stress under different reliability is given.
12. 按风险极小化原则,计算可容许的评定标准,并对其灵敏度给以计算分析。
The permissible evaluation criterion will be calculated according to the risk-minimization principle. The sensitivity of the criterion will also be taken into analysis by calculation.
13. 按风险极小化原则,计算可容许的评定标准,并对其灵敏度给以计算分析。
The permissible evaluation criterion will be calculated according to the risk-minimization principle. The sensitivity of the criterion will also be taken into analysis by calculation.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
