结晶管用英语怎么说,结晶管的英文翻译


词语导航

基本信息

词语:结晶管

繁体:結晶管

拼音:jié jīng guǎn

英语翻译

【化】 crystallizer

分词翻译

结晶的英语翻译:

crystal; crystallization; crystallize
【化】 crystallization
【医】 Crys.; crystal; crystallization

管的英语翻译:

canal; duct; fistula; guarantee; meatus; pipe; tube; wind instrument
【化】 pipe; tube
【医】 canal; canales; canalis; channel; duct; ductus; salpingo-; salpinx
syringo-; tuba; tube; tubi; tubing; tubo-; tubus; vas; vaso-; vessel

翻译例句

1. 本文采用参数泵分步结晶新工艺和开发的直立弹状气泡管结晶器提纯制取精萘,则克服了通常方法的缺点。

In this paper a technology of parametric pumping fractional crystallization and a crystallizer with a slug flow vertical bubble tube are presented.

2. 结果NS牙面涂料在牙本质表面形成结晶,覆盖乃至堵塞牙本质小管。

Results NS paint grew crystal in the dentine surface, occluding dentine tube.

3. 本文对结晶堵管作一肤浅分析,并提出三种解决措施供采卤同行参考。

Brief analysis on pipe plugging by salt crystallization is made and three measures are cited to the colleagues for reference.

4. 结果:牙本质经化合物沉积法处理后,其表面牙本质小管开口被结晶状物质封闭。

RESULT: The SEM pictures showed that the process formed a uniform layer covering and occluded with crystalloid substances in dentinal tubules.

5. 该反应结晶器由上大下小的圆筒、中心加料筒、轴流泵和循环管组成。

The crystallizer consists of a cylinder which is of big top and small bottom, a focus charging cylinder, an axial flow pump and a circulating tube.

6. 通过对oat第一结晶器分布管堵塞原因分析,提出解决分布管堵塞的措施。

Based on analyzing the reasons of the distributing tube clogged up on the first crystallizer of OAT, the measures are taken to prevent the distributing tube clogged up.

7. 目前它是国内最大断面的方坯管式结晶器。

It is currently the largest - section bloom tubular mould in China.

8. 在工业生产条件下测量了连续铸管铸铁结晶器中间环面的温度分布。

Temperature distribution of the middle annular face of the mould in continuous casting pipe processing has been measured in industrial production condition.

9. 太阳能灯是由结晶18V间8瓦特,源10W的发光二极管,硅太阳能电池12V的22A条,等等。

The solar lights was made by crystalline 18V 8w, LED source 10W, silicon solar battery 12V 22A and so on.

10. 结晶装置,结晶方法,薄膜晶体管的制造方法、薄膜晶体管和显示装置。

Crystallization device, crystallization method, film transistor making method, film transistor and display device.WwW.WEntIYI.CoM

11. 莱钢炼钢厂应用高冷却强度结晶器技术,将原组合铜板式断面结晶器改造为高效管式结晶器。

The mould technology with high cooling intensity is adopted in the steel-making plant of Laigang to transform general built-up mould to high effective tube mould.

12. 当使用磁铁矿悬浮液作为催化剂时,得到结晶性良好之竹节状奈米碳管。而在适当条件下,可得到Y接点奈米碳管。

When the magnetite suspension solution was used as catalyst, crystalline bamboo-structured CNTs were obtained. Y junction CNTs were also obtained under ambient condition.

13. 设计和研制了耗尽型选择性掺杂异质结晶体管。

Depletion Model Selective doped heterojunction transistor is designed and fabricated.

14. 利用定时器ne556和程控单结晶体管,设计了一种新型多路脉冲分配器。

Describes a new design of pulse frequency dividers in which timers NE556 and sequence control unijunction transistors are used.

15. 热处理使无定型的氧化钛纳米管阵列结晶,有助于提高其与钛基底的结合强度。

The heat treatment caused crystallization of the amorphous titania nanotube arrays, it contribute to bonding strength with the substrate of titanium.

16. 在焊管生产过程中,焊管本身的变形度、几何尺寸等对其机械性能会产生不利的影响,通过结晶的方法,可以消除这种影响。

The unfavorable effects of deformation magnitude and geometric dimensions on mechanical properties of welded pipes during welding can be eliminated through recrystallization.

17. 半导体结型二极管包括硅,所述硅与硅化物相接触时结晶化。

The semiconductor junction diode comprises silicon, the silicon crystallized in contact with a silicide.

18. 加入碳纳米管后,橡胶dsc曲线中的结晶熔融峰面积减少,交联反应放热峰变宽。

After the adding of carbon nanotubes, the area of crystal-melting peak in DSC curve of rubber decreases, and the width of exotherm peak belongs to cure reaction increases.

19. 催化剂不仅影响碳纳米管的生长速率,而且碳纳米管的直径和管壁的石墨结晶状态也随催化剂的不同而不同。

The results indicate that the growth rate, the diameter, and the crystallinity of CNTs can be manipulated by the selection of the catalysts.

20. 探讨了浇注系统、浇注温度、牵引速度等工艺参数以及内结晶器的冷却腔结构和锥度等对空心管坯成形的影响规律。

The effects of technique parameters, cooling cavity structure and conicity of inner-mold on shaping of hollow tubes were discussed.

21. 碳纳米管在复合材料中充当了成核剂,提高了PA66的成核速度,但降低了其结晶总速度。

Carbon nanotubes in the composite acted as nucleating agent, increased the nucleation rate of PA66, however, reduced its overall rate of crystallization.

22. 通常由一个电阻器或者电流源,电容器和一个“阀门”装置,如氖灯、两端交流开关、单结晶体管或者耿式效应二极管来实现。

It is usually implemented with a resistor or current source, a capacitor, and a "threshold" device such as a neon lamp, diac unijunction transistor, or Gunn diode.

23. 通常由一个电阻器或者电流源,电容器和一个“阀门”装置,如氖灯、两端交流开关、单结晶体管或者耿式效应二极管来实现。

It is usually implemented with a resistor or current source, a capacitor, and a "threshold" device such as a neon lamp, diac unijunction transistor, or Gunn diode.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!