电源启动用英语怎么说，电源启动的英文翻译

词语导航

基本信息

词语：电源启动

繁体：電源啟動

拼音：diàn yuán qǐ dòng

英语翻译

【计】 power initiation

分词翻译

电的英语翻译：

electricity
【计】 telewriting
【化】 electricity
【医】 Elec.; electricity; electro-; galvano-

源的英语翻译：

fountainhead; source
【医】 source

启动的英语翻译：

start-up
【计】 activating; actuating; enablement; startover; startup

翻译例句

1. 介绍一种新的晶闸管中频电源启动电路。

A new thyristor medium-frequency power supply startup circuit is introduced in this article.

2. 我所知道的唯一的解决办法是禁用电源管理，或者使用电源开关重新启动。

The only cure I know is to disable power management, or simply hit the power switch and start over.

3. 完成这些步骤之后，SAN上的Linux将设置为主要的候选磁盘，在服务器电源打开和通过自检运行时将从这里启动。

After doing these steps, Linux on the SAN will be set as the primary candidate disk for booting up when the server powers on and runs through its self check.

4. 与此同时，日本核监管机构说，正着手将外部电源线连接到受损核电站的两个机组上，希望重新启动它们的冷却泵。

At the same time, Japan"s nuclear regulator said it was working to connect outside power cables to two of the units at the stricken plant, in hopes of restarting their cooling pumps.

5. 但是目前还需要提供外部电源来启动这个过程。

Until now, they explained, an external source of electricity was required in order to power the process.

6. 您可以通过按控制器上的PS按钮然后选择Turnoffthe system来重新启动系统，或者通过按电源按钮5秒钟来重新启动系统。

You can either do this by holding down the PS button on the controller and then choosing Turn off the system, or by simply holding the power button down for five seconds.

7. 正确的开机顺序是先开启扫描仪的电源，然后再启动计算机。

Boot order is correct before the power to open the scanner, and then restart the computer.

8. 这种负载对开关电源来说要比电阻负载容易启动。

This load is easier for power supply to start up than resistor load.

9. 当系统启动时，电源指示灯就会闪红光和绿光。

The power light flashes red and green as the system start up.

10. 在这种情况下，您可能必须重新启动您的计算机电源和关闭或手动按下启动按钮。

In such cases, you may have to restart your computer by powering off and on or manually pressing the restart button.

11. 我要到硬盘电源关闭和启动它备份的方式。

I have to to the hard power shut off and start it back up that way.

12. 准备好前面所述的一切，电源管理就可以正常启动了。

Prepared like this you can activate Power Management policies for individual devices.

13. 在此之前的任何行动启动电源后，一高向低过渡CS是必需的。

Prior to the start of any operation after power up, a HIGH to LOW transition on CS is required.

14. 当变频器及PLC发生故障时，自动切换到原软启动柜工频电源运行，以保证压缩机的正常工作。

When frequency converter and PLC is at fault, automatic switch to the original soft start work frequency power operation, ark to ensure the normal work of the compressor.

15. 新闻和释放电源按钮启动计算机。

Press and release the Power Button to start the computer.

16. 打开电源计算机在显示启动画面时都做了些什么工作呢？

Power the computer screen in the show are done to start work?

17. 要启动这台水泵，你得开启电机的电源。

To start your pump, you have to turn on the power of the motor.

18. 如果您离开本单位已启动的20分钟不执行任何操作，自动关机功能会自动关闭电源，避免不必要的电池消耗。

If you leave the unit powered-on for 20 minutes without performing any operation, the auto power off function will turn the power off automatically, avoiding unnecessary battery consumption.

19. 将电源与单控箱连接，不过要注意接线方法。启动跑车，检查其运动方向。

Link the control box to power and start carriage to check its moving direction.

20. 此电路采用基于DSP控制系统的两路开出信号来实现开关电源的软启动。

Two starting out signals of the DSP control system is used to realize switching power supply"s soft start.

21. 但是请小心，如果双数的开关在同时被启动，电源就会恢复，而笼子也就无法打开了。

But be careful, if the number of double-switch was activated at the same time, power will be restored, and it can not open the cage.

22. 重新启动计算机失败。请关闭计算机电源，稍候几秒钟后重新打开电源。

Your computer failed to reboot. You need to power off the computer, wait a few seconds, and power it back on.WwW.wENTIYi.Com

23. 上述步骤完成后，启动程序系统退出工作预备状态，将电源钥匙逆时针旋转取出。

After the steps above are finished, the program system will quit the state of operating preparation. The power key will be drawn out by turning counterclockwise.

24. 按“Y”继续载入组态公用程序，关闭系统电源，然后检查缆线，以确保所有磁碟均在并重新启动。

Press "y" to continue loading the configuration utility or please power off your system and check your cables to ensure all disks are present and reboot.

25. 同时介绍了基于PLC可编程控制器应用于离子泵电源的启动和过流保护的远控系统。

The features of the BEPCII linac vacuum system are described, with the remote monitoring system used in the process of ion pump power starting to normal operation and overflow protection based on PLC.

26. 以SPCE061A单片机位核心，研制了高效、适用的控制系统，包括两个电源的驱动、软启动、净化器的按键及遥控等电路。

This paper studied control system with the center of SPCE061A MCU, including the drive and soft-start circuit of two power supply, the key and distance control of the cleaner.

27. 以SPCE061A单片机位核心，研制了高效、适用的控制系统，包括两个电源的驱动、软启动、净化器的按键及遥控等电路。

This paper studied control system with the center of SPCE061A MCU, including the drive and soft-start circuit of two power supply, the key and distance control of the cleaner.