通导的用英语怎么说,通导的的英文翻译


词语导航

基本信息

词语:通导的

繁体:通導的

拼音:tōng dǎo de

英语翻译

【医】 ecphractic

分词翻译

通的英语翻译:

all; authority; connect; general; go to; notify; open; through; understand
whole
【医】 make; per-

导的英语翻译:

guide; lead; teach; transmit
【医】 guidance; guide

翻译例句

1. 所述第一和第二开关的每一个都交替地进行导通操作和截止操作。

Each of the first and second switches alternatively performs a turn-on operation and a turn-off operation.

2. 该电阻器还应当有足够高的额定功率,以满足齐纳管导通时的功率耗散要求。

The resistor must also be rated high enough to meet the power dissipation requirements while the zeners are conducting.

3. 接地装置引下线的导通检测工作应每年进行一次并进行记录、分析。

Yin Xiaxian of conduction testing should be conducted once a year, and recorded and analyzed.

4. 本文采用辅助高压击穿与能量续流的触发电路来导通真空触发开关tvs,对触发过程中的触发能量和时延特性进行了分析和研究。

Analysis and research were done for the trigger energy and time delay characteristics in the triggering process, using the energy storage and pulse formation trigger circuit to switch on the TVS.

5. 在设计中,以TL 494作为PWM产生电路输出控制信号,控制开关管的导通状况,在半桥反激式输出的基础上实现了电源的多路输出。

In the design, to produce circuit TL494 as a PWM output control signals, control of the on-switch situation, the half-bridge flyback output on the basis of the power of multi-output.

6. 介绍了由单片机控制的可控硅电路,该电路运用外部中断获得同步信号,用定时器做导通角控制,并给出实用程。

The controllable silicon circuit controlled by monolithic microcomputer is introduced, which adopts external interrupt to obtain sync signals and controls conducting angel with a timer.

7. 无论导通时刻是否一致,同臂号晶闸管的关断截止时刻总是相同的。

Whether the turn-on time of the same arm thyristors was uniform or not, the turn-off time was always identical.

8. 是否通过切片检验pth与小导通孔孔壁状况,并有相应的改善对策跟踪?

Is PTH and small via hole wall quality checked by cross-section and followed by a closed loop corrective action?

9. 电路导通器是一种简单的量测仪表,它只能检查电路的通断状况。

The circuit tester is a simple test instrument which only shows whether the circuit is intact or whether there is a break.

10. 启动电流随导通角的增大而减小,控制系统应以大导通角启动,可防止撞缸现象。

So the control system should be started under large Angle of flow in order to avoiding striking the cylinder.

11. 接地装置引下线的导通检测工作应每年进行一次并进行记录、分析。

Grounding device Yin Xiaxian of conduction testing should be conducted once a year, and recorded and analyzed.

12. 本文介绍了在开关磁阻电动机调速系统中对各相绕阻的导通角的设计原理和方法。

This paper introduces design theory and method of conduction Angle of every winding in switching reluctance motor"s regulating system.

13. 介绍了可控电抗器晶闸管导通角的微机控制及应注意的问题,并给出了试验结果和波形。

Microcomputer control of thyristor conduction Angle in controllable reactor and the matter to be noted are introduced. Experimental results and oscillogram are given.

14. 构造考虑齿槽效应的气隙相对磁导函数,计算出气隙磁通密度,进而用麦克斯韦应力张量法计算出电机的磁阻转矩。

The effect of stator slotting being taken into consideration, the air gap relative permeance functions are derived and the flux density in air gap are computed.

15. 结合某样机系统提出了一种用不含CPU的低成本硬件控制器实现的固定导通角p WM控制策略。

Based on a certain prototype, the fixed conducting Angle PWM control strategy implemented by the low cost hardware controller without CPU is proposed.

16. 接地装置引下线的导通检测工作应每年进行一次。

Original: grounding device Yin Xiaxian of conduction testing should be conducted once a year.

17. 通常采用控制晶闸管的导通角,而得到输出连续可调的直流电压。www.WENtiyi.cOm

Usually, the output voltage for continuous adjustment was obtained by controling turn-on angle of thyristor.

18. 本文提出了工作在连续导通情况下DC—DC开关转换器的快速建模的统一方法。

A unified method for fast modelling of dc-dc switching converters in continuous conduction mode (CCM) is proposed in this paper.

19. 利用电压空间矢量脉宽调制(SVPWM)信号变换控制功率变换器各开关器件的导通占空比,实现异步电动机的速度调节。

Using space vector pulse-width modulation (SVPWM) signal transformation method, speed regulation of induction motor is implemented by controlling the duty ratio of every converter switch.

20. 测试功能包括导通测试、断点检测与定位以及短路点的检测。

Its functions include conducting state test, measurement and location of the broken point, and short-circuit point measurement.

21. 与不可导通电边界条件相比,导通裂纹表面的电位移强度因子比不可导通裂纹的电位移强度因子要小许多。

It is found that the electric displacement intensity factors for the permeable crack surface conditions are much smaller than the results for the impermeable crack surface conditions.

22. 在一个给定了输入电压的直流-直流变流器中,输出的平均电压是通过控制开关的导通和关断时间来控制的。

In a dc-dc converter with a given input voltage, the average output voltage is controlled by controlling the switch on and off durations (ton and toff).

23. JTAG边界扫描机制是用于在线导通测试的新技术,利用JTAG可以在数分钟内查出复杂插件和系统的全部导通故障。

JTAG Boundary Scan is a new technique for connection test. With the help of JTAG, we can find out all connection faults of a complicated board or system.

24. 根据电流、电压关系确定器件导通规律,进而计算出器件导通占空比,由此推导出用于分析计算的导通损耗表达式。

The conduction loss expressions are derived based on the knowledge of conduction devices, which are determined by the working condition and the conduction duty cycle.

25. 设计了能保证减振板焊接过程稳定的导通旁路。

Electric accessorial structure is designed to ensure steady welding of vibration-damping sheets.

26. 在车站信号工程的施工中,开通前都要进行车站联锁导通试验,以验证信号设备联锁的正确性。

In construction of signalling system in station, the station conduction test needs to be done to verify the correction of signalling equipment interlocking.

27. 本文研究了有源功率因数校正技术中的临界导通模式的基本原理,并对其中的电压基准源和模拟乘法器做了详细的分析和设计。

In this paper, we studied on critical current mode active Power Factor Correction technology, and did a detailed analysis and design on voltage reference circuit and analog multiplier circuit.

28. 采用新型的连续导通模式(CCM) PF C控制器ice1pcs01,实现了对网侧的PF C控制,具有电路结构简洁、控制调整方便等优点。

ICE1PCS01, the novel continuous conduction mode (CCM) PFC controller, is used for PFC controlling with the considerable merits of succinct circuit structure and easy to adjust control parameters.

29. 采用新型的连续导通模式(CCM) PF C控制器ice1pcs01,实现了对网侧的PF C控制,具有电路结构简洁、控制调整方便等优点。

ICE1PCS01, the novel continuous conduction mode (CCM) PFC controller, is used for PFC controlling with the considerable merits of succinct circuit structure and easy to adjust control parameters.

版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!