
词语导航
基本信息
词语:吸收电路
繁体:吸收電路
拼音:xī shōu diàn lù
英语翻译
【电】 absorbing circuit; absorption circuit
分词翻译
吸收的英语翻译:
absorb; imbibe; soak; assimilate; draw on; drink in; sorb; suck【化】 absorption
【医】 absorb; absorption; resorb; resorption; rhoebdesis
【经】 absorption; assimilation
电路的英语翻译:
circuit; circuitry【计】 electrocircuit
【化】 circuit; electric circuit
【医】 circuit
翻译例句
1. 本文对吸收电路的特性进行了分析。
This paper analyses the absorbing circuits characteristics.
2. 提出一种适用于逆变桥臂模块的吸收电路。
This paper presents a novel passive snubber circuit suitable for inverter bridge leg modules.
3. 由于采用了软栅极控制技术,使二点式、无吸收电路成为可能。
Since the limited grid control technology is applied, the 2 point type, non trap circuit becomes possible.
4. 这种逆变器具有噪音低、损耗小、重量轻、体积小,输出波形好且不需要吸收电路等优点。
The inverter has the advantages of lower noise, lower loss, less volume, lighter weight, better output waveforms and without damping circuit.
5. 这种逆变器具有噪音低、损耗小、重量轻、体积小,输出波形好且不需要吸收电路等优点。
The inverter has the advantages of lower noise, lower loss, less volume, lighter wei…
6. 探讨了IGBT功率电路尖峰电压产生的原因,并针对第三代IGBT,给出了适应不同功率的吸收电路。
The reason of appearing peak voltage in IGBT(insulated gate bipolar transistor)absorber is discussed. Absorbers corrcsponding to different powers are proposed for the 3rd generation IGBT.
7. 本文还对主电路主要功率器件进行了参数计算,包括二极管、IGBT、电容、电感、缓冲吸收电路参数等。
Parameters of main power devices which include diode, IGBT, capacitor, inductance and buffer snubber circuit have been calculated in main circuit in the article.
8. 实验证明,推荐电路具有关断延时短、正负脉冲一致性好、无过冲现象等特点,适宜于TEM发射机的负载能量吸收电路。
Having much less turn-off time, eliminating the current over-shot and improving the turn-off consistency, the proposed snubber is suitable as the load energy snubber of TEM transmitter.
9. 以FF 300r 12me3型IGBT为例给出了模型参数,并将模型应用于IGBT的开关特性分析、缓冲吸收电路设计以及IGBT的并联运行分析。
The parameters of the model were provided for an IGBT of FF300R12ME3 as an example. The model was used in analysis of switching characteristics, snubber circuit, and paralleled operation of the IGBT.
10. 这些电池吸收了阳光中的光子并将它们的能量转移到电子上,由此形成一个电路。
These cells absorb photons in light and transfer their energy to electrons, which form an electrical circuit.
11. 图4 - 2说明使用静电计确定介电吸收的基本电路。
Figure 4-2 illustrates the basic circuit that USES an electrometer to determine dielectric absorption.
12. 这个电路吸收大部分由RLS到地的电流作为Q1的集电极电流。
The circuit siphons off most of the current through RLS to ground as the collector current of Q1.
13. 本文分析了电视机检波电路的原理,从理论上说明了伴音第一中频应吸收的强度,以使图象不受伴音干扰。
This article analyses the principle of detecting circuit in TV receiver. and explains theoretically the correct absorption of first sound IF so as to keep the sound from interfering the picture.
14. 每个器件都有一个八位CMOS移位寄存器和CMOS控制电路,八个CMOS数据锁存,八个双极电流吸收达林顿输出驱动器。
Each device has an eight-bit CMOS shift register and CMOS control circuitry, eight CMOS data latches, and eight bipolar current-sinking Darlington output drivers.
15. 用自行设计的接口电路将8031单片机与H_508原子吸收分光光度计连接,以很低的成本使仪器计算机化,灵敏度提高且效果良好。
A new interface was designed for connecting a model 8031 chip microprocessor with H_508 atomic absorption spectrometer and the computer control of the AAS instrument was realized with very low cost.
16. 介绍由MOSFET管构成的全桥开关电路在感性负载下大电流工作时两种吸收回路的实验研究结果。
This paper introduces the experimental results of two snubber circuits for the full bridge switch circuit constituted by MOSFETs in case of the inductive load and large current operation.
17. 基于这些方程,研究了实现软开关的条件,并从关断损耗和占空比丢失的角度探讨了吸收电容与电路最高工作频率的关系,给出了工程设计公式。
Based on the equations, the condition of ZVS is analyzed, and the engineering design method of highest working frequency is discussed, which is based on dissipation of turning off and duty cycle lose.
18. 研究了正交排布的碳纤维吸波复合材料的微波吸收特性,结果表明这种类似电路模拟材料的排布方式可使材料获得优异的吸波性能。
Microwave absorbing properties of circuit analog materials produced by carbon fiber were studied. The composites showed excellent results at the condition of this arrangement.
19. 分析了吸收式气体传感器的工作数学模型与光电检测电路的结构特点,探讨了提高吸收式光纤气体传感器分辨率的方法。
According to the mathematic model of gas sensor and the photoelectric detection circuit structure characteristic, it discusses the methods of improving resolution in detail.
20. 通过双限流电路和浪涌强制吸收或隔离保护电路的设计,解决了大功率半导体激光器驱动电源常见的浪涌冲击和电流恒定的难题。
The double limit current circuit and electronic surge force absorbed or isolated circuit are introduced. The problems of electronic surge strike and current stable are solved.WWW.wEnTiYi.com
21. 对功率因数校正器辅助电路中的滤波电路设计、起动电流抑制电路的设计和开关的浪涌吸收保护电路的设计进行了分析。
The design of the filter circuit, starting current check circuit and switching surge absorption-protection circuit in an auxiliary circuit of PFC is analyzed.
22. 对功率因数校正器辅助电路中的滤波电路设计、起动电流抑制电路的设计和开关的浪涌吸收保护电路的设计进行了分析。
The design of the filter circuit, starting current check circuit and switching surge absorption-protection circuit in an auxiliary circuit of PFC is analyzed.
版权声明:问题易所有作品(图文、音视频)均来源网络,版权归原创作者所有,与本站立场无关,如不慎侵犯了你的权益,请联系我们告知,我们将做删除处理!
